| Message ID | cover.1599029334.git.matti.vaittinen@fi.rohmeurope.com |
|---|---|
| Headers | show |
| Series | Support regulator ON/OFF by PMIC state machine. | expand |
On Thu, 3 Sep 2020 21:37:51 +0300, Matti Vaittinen wrote: > Support regulator enable/disable via BD718(37/47/50) PMIC state machine. > > The ROHM BD718(37/47/50) PMICs are mainly used for powering i.MX8 based > systems. On some setups the i.MX8 SoC uses a IO line to suspend the > system. These PMICs support this via PMIC internal HW state machine > which can be toggled for example by the PMIC_STBY_REQ IO-pin. > > [...] Applied to https://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator.git for-next Thanks! [1/4] regulator: bd718x7 initialize regulator config only once commit: df9db2541a82ec18c474942a93729420d37fac81 [2/4] regulator: bd71837: add property for omitting ON/OFF control commit: 4788c692bec76dc33c646a07a4aaf7e2dd60091e [3/4] regulator: bd71847: add property for omitting ON/OFF control commit: 6656d4462c7ac5ca0bc5d5a8a91a8c98f0fd1409 [4/4] regulator: bd718x7 fix regulator states at SUSPEND commit: 1d848d681c4d4e148193b699a6e5f222e8621519 All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted. You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed. If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced. Please add any relevant lists and maintainers to the CCs when replying to this mail. Thanks, Mark
Support regulator enable/disable via BD718(37/47/50) PMIC state machine. The ROHM BD718(37/47/50) PMICs are mainly used for powering i.MX8 based systems. On some setups the i.MX8 SoC uses a IO line to suspend the system. These PMICs support this via PMIC internal HW state machine which can be toggled for example by the PMIC_STBY_REQ IO-pin. Regulators can be controlled either by this state machine or by SW via I2C. This patch series allows mixed control model by adding a device-tree property which is intended to be used to leave some of the regulators under HW state machine control while allowing other to be still controlled using the driver. The driver can also be used to set voltages levels for all regulators no matter if enable/disable state is controlled by SW or HW. --- Matti Vaittinen (4): regulator: bd718x7 initialize regulator config only once dt-bindings: regulator: bd71837: add property for omitting ON/OFF control dt-bindings: regulator: bd71847: add property for omitting ON/OFF control regulator: bd718x7 fix regulator states at SUSPEND .../regulator/rohm,bd71837-regulator.yaml | 11 + .../regulator/rohm,bd71847-regulator.yaml | 11 + drivers/regulator/bd718x7-regulator.c | 422 +++++++++++------- 3 files changed, 293 insertions(+), 151 deletions(-)