Message ID | 20190412130427.13418-1-angus@akkea.ca |
---|---|
Headers | show |
Series | Add support for the Purism Librem5 devkit | expand |
> + mdio { > + #address-cells = <1>; > + #size-cells = <0>; > + > + ethphy0: ethernet-phy@1 { > + compatible = "ethernet-phy-ieee802.3-c22"; Hi Angus This compatible string is optional. It won't warm, but it is not needed. > + reg = <1>; > + power-supply = <®_3V3_P>; I don't remember seeing a power-supply property in an Ethernet PHY node before. What is using it? The PHY driver? Or the driver core code? Andrew
On Fri, 2019-04-12 at 07:04 -0600, Angus Ainslie (Purism) wrote: > +&i2c1 { > + clock-frequency = <400000>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_i2c1>; > + status = "okay"; > + > + pmic: pmic@4b { > + reg = <0x4b>; > + compatible = "rohm,bd71837"; > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_pmic>; > + clocks = <&pmic_osc>; > + clock-names = "osc"; > + clock-output-names = "pmic_clk"; > + interrupt-parent = <&gpio1>; > + interrupts = <3 GPIO_ACTIVE_LOW>; > + interrupt-names = "irq"; > + rohm,reset-snvs-powered; > + > + gpo { > + /* 0b0000_1100 all gpos with cmos output mode > */ > + rohm,drv = <0x0C>; > + }; After searching for this gpo/rohm,drv property it does not seem to be documented or handled anywhere? Should probably just drop. > + regulators { > + #address-cells = <1>; > + #size-cells = <0>; > + > + buck1_reg: BUCK1@0 { > + reg = <0>; > + regulator-name = "buck1"; > + regulator-min-microvolt = <700000>; > + regulator-max-microvolt = <1300000>; > + regulator-boot-on; > + regulator-always-on; > + regulator-ramp-delay = <1250>; > + rohm,dvs-run-voltage = <900000>; > + rohm,dvs-idle-voltage = <850000>; > + rohm,dvs-suspend-voltage = <800000>; > + }; > + > + buck2_reg: BUCK2@1 { > + reg = <1>; > + regulator-name = "buck2"; > + regulator-min-microvolt = <700000>; > + regulator-max-microvolt = <1300000>; > + regulator-boot-on; > + regulator-always-on; > + regulator-ramp-delay = <1250>; > + rohm,dvs-run-voltage = <1000000>; > + rohm,dvs-idle-voltage = <900000>; > + }; > + > + buck3_reg: BUCK3@2 { > + reg = <2>; > + regulator-name = "buck3"; > + regulator-min-microvolt = <700000>; > + regulator-max-microvolt = <1300000>; > + rohm,dvs-run-voltage = <1000000>; > + }; > + > + buck4_reg: BUCK4@3 { > + reg = <3>; > + regulator-name = "buck4"; > + regulator-min-microvolt = <700000>; > + regulator-max-microvolt = <1300000>; > + rohm,dvs-run-voltage = <1000000>; > + }; > + > + buck5_reg: BUCK5@4 { > + reg = <4>; > + regulator-name = "buck5"; > + regulator-min-microvolt = <700000>; > + regulator-max-microvolt = <1350000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + buck6_reg: BUCK6@5 { > + reg = <5>; > + regulator-name = "buck6"; > + regulator-min-microvolt = <3000000>; > + regulator-max-microvolt = <3300000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + buck7_reg: BUCK7@6 { > + reg = <6>; > + regulator-name = "buck7"; > + regulator-min-microvolt = <1605000>; > + regulator-max-microvolt = <1995000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + buck8_reg: BUCK8@7 { > + reg = <7>; > + regulator-name = "buck8"; > + regulator-min-microvolt = <800000>; > + regulator-max-microvolt = <1400000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + ldo1_reg: LDO1@8 { > + reg = <8>; > + regulator-name = "ldo1"; > + regulator-min-microvolt = <3000000>; > + regulator-max-microvolt = <3300000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + ldo2_reg: LDO2@9 { > + reg = <9>; > + regulator-name = "ldo2"; > + regulator-min-microvolt = <900000>; > + regulator-max-microvolt = <900000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + ldo3_reg: LDO3@10 { > + reg = <10>; > + regulator-name = "ldo3"; > + regulator-min-microvolt = <1800000>; > + regulator-max-microvolt = <3300000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + ldo4_reg: LDO4@11 { > + reg = <11>; > + regulator-name = "ldo4"; > + regulator-min-microvolt = <900000>; > + regulator-max-microvolt = <1800000>; > + regulator-boot-on; > + regulator-always-on; > + }; > + > + ldo5_reg: LDO5@12 { > + reg = <12>; > + regulator-name = "ldo5"; > + regulator-min-microvolt = <1800000>; > + regulator-max-microvolt = <3300000>; > + }; > + > + ldo6_reg: LDO6@13 { > + reg = <13>; > + regulator-name = "ldo6"; > + regulator-min-microvolt = <900000>; > + regulator-max-microvolt = <1800000>; > + }; > + > + ldo7_reg: LDO7@14 { > + reg = <14>; > + regulator-name = "ldo7"; > + regulator-min-microvolt = <1800000>; > + regulator-max-microvolt = <3300000>; > + }; > + }; > + };
On 2019-04-12 07:39, Leonard Crestez wrote: > On Fri, 2019-04-12 at 07:04 -0600, Angus Ainslie (Purism) wrote: >> +&i2c1 { >> + clock-frequency = <400000>; >> + pinctrl-names = "default"; >> + pinctrl-0 = <&pinctrl_i2c1>; >> + status = "okay"; >> + >> + pmic: pmic@4b { >> + reg = <0x4b>; >> + compatible = "rohm,bd71837"; >> + pinctrl-names = "default"; >> + pinctrl-0 = <&pinctrl_pmic>; >> + clocks = <&pmic_osc>; >> + clock-names = "osc"; >> + clock-output-names = "pmic_clk"; >> + interrupt-parent = <&gpio1>; >> + interrupts = <3 GPIO_ACTIVE_LOW>; >> + interrupt-names = "irq"; >> + rohm,reset-snvs-powered; >> + >> + gpo { >> + /* 0b0000_1100 all gpos with cmos output mode >> */ >> + rohm,drv = <0x0C>; >> + }; > > After searching for this gpo/rohm,drv property it does not seem to be > documented or handled anywhere? > > Should probably just drop. Right I can't find it in the driver either. I'll drop it. Thanks Angus > >> + regulators { >> + #address-cells = <1>; >> + #size-cells = <0>; >> + >> + buck1_reg: BUCK1@0 { >> + reg = <0>; >> + regulator-name = "buck1"; >> + regulator-min-microvolt = <700000>; >> + regulator-max-microvolt = <1300000>; >> + regulator-boot-on; >> + regulator-always-on; >> + regulator-ramp-delay = <1250>; >> + rohm,dvs-run-voltage = <900000>; >> + rohm,dvs-idle-voltage = <850000>; >> + rohm,dvs-suspend-voltage = <800000>; >> + }; >> + >> + buck2_reg: BUCK2@1 { >> + reg = <1>; >> + regulator-name = "buck2"; >> + regulator-min-microvolt = <700000>; >> + regulator-max-microvolt = <1300000>; >> + regulator-boot-on; >> + regulator-always-on; >> + regulator-ramp-delay = <1250>; >> + rohm,dvs-run-voltage = <1000000>; >> + rohm,dvs-idle-voltage = <900000>; >> + }; >> + >> + buck3_reg: BUCK3@2 { >> + reg = <2>; >> + regulator-name = "buck3"; >> + regulator-min-microvolt = <700000>; >> + regulator-max-microvolt = <1300000>; >> + rohm,dvs-run-voltage = <1000000>; >> + }; >> + >> + buck4_reg: BUCK4@3 { >> + reg = <3>; >> + regulator-name = "buck4"; >> + regulator-min-microvolt = <700000>; >> + regulator-max-microvolt = <1300000>; >> + rohm,dvs-run-voltage = <1000000>; >> + }; >> + >> + buck5_reg: BUCK5@4 { >> + reg = <4>; >> + regulator-name = "buck5"; >> + regulator-min-microvolt = <700000>; >> + regulator-max-microvolt = <1350000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + buck6_reg: BUCK6@5 { >> + reg = <5>; >> + regulator-name = "buck6"; >> + regulator-min-microvolt = <3000000>; >> + regulator-max-microvolt = <3300000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + buck7_reg: BUCK7@6 { >> + reg = <6>; >> + regulator-name = "buck7"; >> + regulator-min-microvolt = <1605000>; >> + regulator-max-microvolt = <1995000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + buck8_reg: BUCK8@7 { >> + reg = <7>; >> + regulator-name = "buck8"; >> + regulator-min-microvolt = <800000>; >> + regulator-max-microvolt = <1400000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + ldo1_reg: LDO1@8 { >> + reg = <8>; >> + regulator-name = "ldo1"; >> + regulator-min-microvolt = <3000000>; >> + regulator-max-microvolt = <3300000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + ldo2_reg: LDO2@9 { >> + reg = <9>; >> + regulator-name = "ldo2"; >> + regulator-min-microvolt = <900000>; >> + regulator-max-microvolt = <900000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + ldo3_reg: LDO3@10 { >> + reg = <10>; >> + regulator-name = "ldo3"; >> + regulator-min-microvolt = <1800000>; >> + regulator-max-microvolt = <3300000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + ldo4_reg: LDO4@11 { >> + reg = <11>; >> + regulator-name = "ldo4"; >> + regulator-min-microvolt = <900000>; >> + regulator-max-microvolt = <1800000>; >> + regulator-boot-on; >> + regulator-always-on; >> + }; >> + >> + ldo5_reg: LDO5@12 { >> + reg = <12>; >> + regulator-name = "ldo5"; >> + regulator-min-microvolt = <1800000>; >> + regulator-max-microvolt = <3300000>; >> + }; >> + >> + ldo6_reg: LDO6@13 { >> + reg = <13>; >> + regulator-name = "ldo6"; >> + regulator-min-microvolt = <900000>; >> + regulator-max-microvolt = <1800000>; >> + }; >> + >> + ldo7_reg: LDO7@14 { >> + reg = <14>; >> + regulator-name = "ldo7"; >> + regulator-min-microvolt = <1800000>; >> + regulator-max-microvolt = <3300000>; >> + }; >> + }; >> + };