| Message ID | 20190105004904.17947-2-nicoleotsuka@gmail.com |
|---|---|
| State | Not Applicable, archived |
| Headers | show |
| Series | hwmon (ina3221) Add single-shot mode support | expand |
| Context | Check | Description |
|---|---|---|
| robh/checkpatch | success |
On Fri, 4 Jan 2019 16:49:03 -0800, Nicolin Chen wrote: > By default, ina3221, as a hardware monitor, continuously measures > the inputs and generates corresponding data. However, for battery > powered devices, this mode might be power consuming. > > This patch adds a "ti,single-shot" property to allow changing the > default continuous mode to single-shot operating mode. > > Signed-off-by: Nicolin Chen <nicoleotsuka@gmail.com> > --- > Documentation/devicetree/bindings/hwmon/ina3221.txt | 10 ++++++++++ > 1 file changed, 10 insertions(+) > Reviewed-by: Rob Herring <robh@kernel.org>
diff --git a/Documentation/devicetree/bindings/hwmon/ina3221.txt b/Documentation/devicetree/bindings/hwmon/ina3221.txt index a7b25caa2b8e..fa63b6171407 100644 --- a/Documentation/devicetree/bindings/hwmon/ina3221.txt +++ b/Documentation/devicetree/bindings/hwmon/ina3221.txt @@ -6,6 +6,16 @@ Texas Instruments INA3221 Device Tree Bindings - reg: I2C address Optional properties: + - ti,single-shot: This chip has two power modes: single-shot (chip takes one + measurement and then shuts itself down) and continuous ( + chip takes continuous measurements). The continuous mode is + more reliable and suitable for hardware monitor type device, + but the single-shot mode is more power-friendly and useful + for battery-powered device which cares power consumptions + while still needs some measurements occasionally. + If this property is present, the single-shot mode will be + used, instead of the default continuous one for monitoring. + = The node contains optional child nodes for three channels = = Each child node describes the information of input source =
By default, ina3221, as a hardware monitor, continuously measures the inputs and generates corresponding data. However, for battery powered devices, this mode might be power consuming. This patch adds a "ti,single-shot" property to allow changing the default continuous mode to single-shot operating mode. Signed-off-by: Nicolin Chen <nicoleotsuka@gmail.com> --- Documentation/devicetree/bindings/hwmon/ina3221.txt | 10 ++++++++++ 1 file changed, 10 insertions(+)