Message ID | 1522419526-29494-12-git-send-email-bryan.odonoghue@linaro.org |
---|---|
State | Superseded |
Delegated to: | Stefano Babic |
Headers | show |
Series | warp7: Enable automated OPTEE/HAB boot flow | expand |
Hi Bryan, On Fri, Mar 30, 2018 at 11:18 AM, Bryan O'Donoghue <bryan.odonoghue@linaro.org> wrote: > Adding CONFIG_WARP7_ROOT_PART allows a defconfig to specify which partition > is use as the root partition on WaRP7, this is a desirable change in order > to support a different partitioning schemes. The default is the current > partition #1. I think you meant "partition #2" here instead.
diff --git a/board/warp7/Kconfig b/board/warp7/Kconfig index 00df19d..c089bca 100644 --- a/board/warp7/Kconfig +++ b/board/warp7/Kconfig @@ -6,6 +6,14 @@ config SYS_BOARD config SYS_CONFIG_NAME default "warp7" +config WARP7_ROOT_PART + int "Partition number to use for root filesystem" + default 2 + help + The partition number to use for root filesystem this is the + partition that is typically specified with root=/dev/sdaX or + which gets converted into a root=PARTUUID=some_uuid. + config SYS_FDT_ADDR hex "FDT load address" default 0x83000000
Adding CONFIG_WARP7_ROOT_PART allows a defconfig to specify which partition is use as the root partition on WaRP7, this is a desirable change in order to support a different partitioning schemes. The default is the current partition #1. Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> --- board/warp7/Kconfig | 8 ++++++++ 1 file changed, 8 insertions(+)