@@ -1099,15 +1099,8 @@ static int smsc911x_mii_init(struct platform_device *pdev,
goto err_out_free_bus_2;
}
- if (smsc911x_mii_probe(dev) < 0) {
- SMSC_WARN(pdata, probe, "Error registering mii bus");
- goto err_out_unregister_bus_3;
- }
-
return 0;
-err_out_unregister_bus_3:
- mdiobus_unregister(pdata->mii_bus);
err_out_free_bus_2:
mdiobus_free(pdata->mii_bus);
err_out_1:
@@ -1522,18 +1515,20 @@ static int smsc911x_open(struct net_device *dev)
unsigned int intcfg;
int retval;
- /* if the phy is not yet registered, retry later*/
+ /* find and start the given phy */
if (!dev->phydev) {
- SMSC_WARN(pdata, hw, "phy_dev is NULL");
- retval = -EAGAIN;
- goto out;
+ retval = smsc911x_mii_probe(dev);
+ if (retval < 0) {
+ SMSC_WARN(pdata, probe, "Error starting phy");
+ goto out;
+ }
}
/* Reset the LAN911x */
retval = smsc911x_soft_reset(pdata);
if (retval) {
SMSC_WARN(pdata, hw, "soft reset failed");
- goto out;
+ goto mii_free_out;
}
smsc911x_reg_write(pdata, HW_CFG, 0x00050000);
@@ -1604,7 +1599,7 @@ static int smsc911x_open(struct net_device *dev)
netdev_warn(dev, "ISR failed signaling test (IRQ %d)\n",
dev->irq);
retval = -ENODEV;
- goto out;
+ goto mii_free_out;
}
SMSC_TRACE(pdata, ifup, "IRQ handler passed test using IRQ %d",
dev->irq);
@@ -1650,6 +1645,10 @@ static int smsc911x_open(struct net_device *dev)
netif_start_queue(dev);
return 0;
+
+mii_free_out:
+ phy_disconnect(dev->phydev);
+ dev->phydev = NULL;
out:
return retval;
}
@@ -1674,8 +1673,12 @@ static int smsc911x_stop(struct net_device *dev)
smsc911x_tx_update_txcounters(dev);
/* Bring the PHY down */
- if (dev->phydev)
+ if (dev->phydev) {
phy_stop(dev->phydev);
+ phy_disconnect(dev->phydev);
+ dev->phydev = NULL;
+ }
+ netif_carrier_off(dev);
SMSC_TRACE(pdata, ifdown, "Interface stopped");
return 0;
@@ -2297,11 +2300,10 @@ static int smsc911x_drv_remove(struct platform_device *pdev)
pdata = netdev_priv(dev);
BUG_ON(!pdata);
BUG_ON(!pdata->ioaddr);
- BUG_ON(!dev->phydev);
+ WARN_ON(dev->phydev);
SMSC_TRACE(pdata, ifdown, "Stopping driver");
- phy_disconnect(dev->phydev);
mdiobus_unregister(pdata->mii_bus);
mdiobus_free(pdata->mii_bus);
@@ -2500,6 +2502,12 @@ static int smsc911x_drv_probe(struct platform_device *pdev)
netif_carrier_off(dev);
+ retval = smsc911x_mii_init(pdev, dev);
+ if (retval) {
+ SMSC_WARN(pdata, probe, "Error %i initialising mii", retval);
+ goto out_free_irq;
+ }
+
retval = register_netdev(dev);
if (retval) {
SMSC_WARN(pdata, probe, "Error %i registering device", retval);
@@ -2509,12 +2517,6 @@ static int smsc911x_drv_probe(struct platform_device *pdev)
"Network interface: \"%s\"", dev->name);
}
- retval = smsc911x_mii_init(pdev, dev);
- if (retval) {
- SMSC_WARN(pdata, probe, "Error %i initialising mii", retval);
- goto out_unregister_netdev_5;
- }
-
spin_lock_irq(&pdata->mac_lock);
/* Check if mac address has been specified when bringing interface up */
@@ -2550,8 +2552,6 @@ static int smsc911x_drv_probe(struct platform_device *pdev)
return 0;
-out_unregister_netdev_5:
- unregister_netdev(dev);
out_free_irq:
free_irq(dev->irq, dev);
out_disable_resources:
Move phy startup/shutdown into the smsc911x_open/stop routines. This allows the module to be unloaded because phy_connect_direct is no longer always holding the module use count. This one change also resolves a number of other problems. The link status of a downed interface no longer reflects a stale state. Errors caused by the net device being opened before the mdio/phy was configured. There is also a potential power savings as the phy's don't remain powered when the interface isn't running. Signed-off-by: Jeremy Linton <jeremy.linton@arm.com> --- drivers/net/ethernet/smsc/smsc911x.c | 48 ++++++++++++++++++------------------ 1 file changed, 24 insertions(+), 24 deletions(-)